Product Instruction:

The Chemical and Abrasion Resistant gear pump head and motor are integrated, and the brushless driver is integrated in the motor tail, which makes the product structure compact and more suitable for the occasions with narrow installation space. 

PPS 0.60ml/rev Gear Pump is a positive displacement gear pump which realizes non-contact torque transmission through magnetic driver, so as to replace dynamic seal with static seal and make the pump completely leak free. Ceramic ink pump is suitable for petroleum, chemical, national defense and other industries.

Attentions:  

1.400 Mesh filter shall be installed at the inlet of gear pump.  

2.This gear pump is suitable for continuous operation for a long time and can not be used under the condition of frequent start and stop.

3.Before using, squeeze in a small amount of medium to lubricate the gear from the gear pump inlet.

Product Model Selection Instruction：

Notes:

1. Pump output volume: 0.07,0.15,0.3,0.6,0.9,1.5,3.0,6.,12.0 (Unit: ml/rev)

2."S" means pump body material is 316L, gear and shaft sleeve are PEEK, seal with PTFE, the rest others are 316L.

   "T" means pump body material is 316L, gear and shaft are Tungsten steel, shaft sleeve is PEEK, seal with PTFE, the rest others are 316L.

  "P" means pump body material is PPS, gear materail and shaft sleeve are PEEK, seal with FFKM, the rest others are Hastelloy.

  "H" means the pump body materials is Hastelloy, the gear and shaft sleeve is PEEK, the seal materials is PTFE, the rest of the pump flow material is Hastelloy, the appearance and size is same as 316L pump, details product parameters refer to 316L pump head.

Product Model : I0.60P70W

Product Diagram:

The values in this table are for reference only.

Remarks:
OEM service are avaiable according to your request.
The specifications are only for reference, for details checking, please feel free to contact us.

70W Motor Instruction

Motor parameter

（Number of phase）	N	3
（Rated Voltage）	VDC	24（8-30VDC）
（Rated Power）	W	70W
（Speed regulating voltage）	VDC	0-5   (0.35V ON   0.3V OFF)
（Range of speeds）	RPM	500-5000
（Maximum current）	A	3.3A
（Instantaneous protection current）	A	5A

Wiring instructions

Secure features

Operation protection: when the motor running current reaches the limit current of 3.3A, the motor drive  will start the protection and stop running.

Locked rotor protection: when the pump body is locked, the drive will start the protection function and  cut off the internal power supply of the motor.

Software / hardware over-current protection: when the system detects that the instantaneous current of software and hardware inside the motor is greater than 5a, the drive will start the protection.

Hall error protection: when the motor Hall sensor failure, the motor will start protection stop running, to prevent burning the motor.

Under voltage protection: when the operating voltage is lower than the specified range, it will stop operation.

Performance data

Note:The valve door is fully opened and tested under no-load condition

Note:The valve door is blocked and tested under full load conditio