Medical oxygen bubble humidification bottle

Medical oxygen bubble humidification bottle

The first aid box humidification bottle vortex flowmeter has small measurement error, wide measurement range, simple structure, and convenient installation and use. Therefore, the first-aid kit humidification bottle can be widely used in places where the flow of gas, liquid and steam needs to be measured, such as the first-aid humidification bottle supply company of thermal power plants, paper mills, printing and dyeing factories, textile factories, and chemical plants. Fiber plants, metallurgical plants, steel plants, petrochemical plants, mines, power plants, oil fields, medical plants, biological plants, food plants, fine chemical plants, schools and scientific research institutions.

We are a professional manufacturer of medical products, providing high-quality medical equipment and medical consumables design and R&D services. So far, our products include: Electrocardiograph Detector, medical goggles, isolation gown, Electronic thermometer, Mercury Thermometer, oxygen generator, atomizing cup, disposable syringe, safety gloves, Disposable Dental Needle, KN95 Protective Mask, Air purifier, etc. ; Xuanweicheng Biotechnology Co., Ltd. is not only a supplier of health products, but also a health consultant for your family. Promote you and your family to develop good living habits, care and promote the health of you and your family.

Specification

Using Method

1. oxygen-inlet screw with oxygen cylinder tightly, then open oxygen cylinder valve;

2.Insert oxygen-inhale pipe to oxygen outlet and connect it tightly;

Screw down humidifier, add pure water until between upper and lower water line, then screw the humidifier with the cap of the humidifier tightly;

3.Adjust the flow adjuster until to the flow you want, then breath oxygen by oxygeninhale pipe;

4.Close the oxygen cylinder valve when you stop oxygen breathing, then close the flow adjuster when the needle of the pressure gauge points at " 0".

Notice

1.Clean the connector of the oxygen cylinder and test the connecting screw before install the oxygen regulator.

2.Make the flow meter vertical to the ground and close the flow adjuster, then open the oxygen cylinder valve slowly, when oxygen cylinder pressure shows on the pressure gauge then adjust flow of the oxygen outlet.

3.Forbidden heavy quake, corrosive material and oil.

4.The fixed screw of safety valve must not be screwed optionally, laypeople forbidden dismounting.

 

Packing and shipping

1 pcs/bag, 20 pcs/carton