conventional positive ps plate options
- Transportation:
- Ocean, Land, Air
- Port:
- ShangHai Port, Ningbo Port
Your message must be between 20 to 2000 characters
Contact Now| Place of Origin: | China |
|---|---|
| Supply Ability: | Strong |
| Payment Type: | L/C,T/T,D/P |
| Incoterm: | FOB,CFR,CIF,EXW |
| Transportation: | Ocean,Land,Air |
| Port: | ShangHai Port,Ningbo Port |
Conventional positive PS plate options is the only material in line with the national environmental protection standards, and has been widely used in the development so far. Today xiaobian will talk about the installation of PC board notes.
Conventional Postive Ps Plate Magnetic installation is easy to cause deformation or crack, so we should pay attention to the following points in the installation of PC Plate:
The diameter of the leading hole should exceed 6-9mm of the diameter of the fixed fixed screw before the Conventional Postive Ps Plate Number is used for hot expansion and cold contraction.
2. When fixed, be sure to use a better roof drainage sealing ring, so that it is close to the middle of the screw and PC Plate, easy to moisture-proof and anti-fouling.
3 PC plate and thick steel plate in the transverse reinforcement lap, be sure to have
200mm of overlap, and paste two rubber sealing
Conventional positive PS plate options is the only material in line with the national environmental protection standards, and has been widely used in the development so far. Today xiaobian will talk about the installation of PC board notes.
Conventional Postive Ps Plate Magnetic installation is easy to cause deformation or crack, so we should pay attention to the following points in the installation of PC Plate:
The diameter of the leading hole should exceed 6-9mm of the diameter of the fixed fixed screw before the Conventional Postive Ps Plate Number is used for hot expansion and cold contraction.
2. When fixed, be sure to use a better roof drainage sealing ring, so that it is close to the middle of the screw and PC Plate, easy to moisture-proof and anti-fouling.
3 PC plate and thick steel plate in the transverse reinforcement lap, be sure to have
200mm of overlap, and paste two rubber sealing
|
YP-II POSITIVE PS PLATE |
|
|
Plate type |
Positive |
|
Application |
Commercial sheetfed and rotary press printing |
|
Substrate |
Electro-chemically grained and anodized lithographic aluminum. |
|
Gauge |
0.15/0.25/0.30/0.40mm |
|
Maximum width |
1320mm |
|
Spectrum scope |
350-420nm |
|
Sensitivity |
130-150mj/cm2 |
|
Safe light |
UV filtered or Yellow light |
|
Coating color |
Green |
|
Dot reproduction |
2%-98%@ 200lpi Depend upon capability of imaging device |
|
Run length |
Above 100,000 |
|
Developer |
Huaguang PD developer (concentrated solution), |
|
Development |
1 liter can process 15 sqm Developer dilute ratio: 1:4(machine)-1:6(hand) Developing Temperature: 24-26℃ Developing Time: 20-30secs |
|
Packaging |
0.15mm 100 pieces/box 0.25/0.30mm 50 pieces/box if length <1030mm; 30 pieces/box if length ≥1030mm; 25 pieces/box if the area > 1m2 |
Related Keywords
