Din En 10305-4 Tube

Get Latest Price

Quantity:

Your message must be between 20 to 2000 characters

Contact Now

Basic Info

Product Description

DIN EN 10305-4 Tube

A number of options are specified in this Part of EN 10305 and these are listed below. In the event that the

purchaser does not indicate a wish to implement any of these options at the time of enquiry and order, the tubes

shall be supplied in accordance with the basic specification

1) Specification of a steel grade not specified in this Part of EN 10305;

2) specification of a sulphur range to support machinability

3) surface condition for further processing ;

4) measurement of surface roughness ;

5) lower surface roughness

6) defined removable substances on surface

7) non-destructive testing for the detection of longitudinal imperfections

8) non-destructive testing for verification of leak-tightness

9) agreement on a cross section other than circular

10) tubes specified by outside or inside diameter and wall thickness

11) reduced diameter tolerances

12) diameter tolerances unilateral

13) reduced concentricity

14) reduced wall thickness tolerance

15) wall thickness tolerance unilateral

16) agreement on a tolerance for exact lengths £ 500 mm or > 8 000 mm

17) specified end finishing

18) specific inspection ;

19) inspection certificates 3.1.A or 3.1.C ;

20) flattening or drift expanding test;

21) test unit with tubes from one cast only

22) alternative marking ;

23) delivery without corrosion protection

24) specified corrosion protection

25) specified method of packaging

Send your message to this supplier